Ford Bronco 2021-2026 Gen 6 LED Dual Ditch Mounts Brackets - A Pillar - Hardware Included

Illuminate your Ford Bronco’s trails with these custom Double Ditch Light Brackets, designed to fit 2021–2026 full-size Broncos. Crafted by a fellow Bronco enthusiast and printed in durable ASA, these brackets have been battle-tested through Carolina summers—no warping or failure! Simply bolt on your 4″ LED ditch lights for instant off-road visibility. 🔦🌲

Compatible with 4″ LED Pods that use 1× M8 mounting bolt per light (see Fitment below)

🔧 What You’re Getting:

Pair of 3D-Printed Brackets (driver & passenger side) in high-strength ASA

4x M6 x 25mm mounting bolts: for the Pre-drilled Mounting holes

💡 Designed For These 4″ LED Lights:

BEEYEO 4″ LED Ditch Lights (Amzn ASIN: B07TYWQ6RV)

LEDMARK 4″ LED Pod Lights (Amzn ASIN: B0D17M6WTG)

Other 4″ Offroad Light Pods with standard M8 mounting pattern

Tip: If your light’s bolt pattern matches the brackets, these can adapt to many other 4″ pod lights!

✅ Key Features:

Durable ASA Construction – Heat-resistant and UV-stable for long-term outdoor use.

Factory-Fit Design – Bolts onto stock ditch-light bosses without modification.

🛠️ Installation Steps:

Remove Factory Caps: Pop off the blanking caps on both driver and passenger ditch-light holes.

Test-Fit Brackets: Align each bracket’s M6 holes with the factory bosses—ensure a flush fit.

Secure Brackets: Insert 4× M6 × 25 mm bolts (not included) through the bracket into the bosses. Tighten until snug (do not overtighten).

Mount Your 4″ LED Pods: Attach each light to the bracket using 1× M8 mounting bolt (typically included with your light kit).

Aim & Wire: Point lights as desired (you may need to remove your antenna for the inner passenger-side bracket to face perfectly forward). Route wiring behind the fender liner and connect to a fused power source.

📏 Specs & Fitment:

Bracket Dimensions:

Center-to-Center Boss Spacing: ~75 mm (matches factory ditch-light bosses)

Bracket Depth: ~40 mm (provides proper clearance for 4″ pods)

Height Above Fender: ~50 mm (optimal beam projection)

Bolt Pattern:

Bracket to Bronco: M6 threads (use 25 mm length bolts)

Light to Bracket: M8 bolt (standard on most 4″ pod lights)

Material: High-strength ASA (heat and UV resistant)

Hardware:

4 M6 × 25 mm bolts (for bracket)

⚙️ Note From the Maker!

This part is 3D-printed, not OEM — so it may not look factory-perfect 👀… but it works like a charm 🔥💯

You might see some layer lines or texture – that’s just 3D-printing character 😎